Filter
Top Products
22
X. TO REPLACE MAIN DOOR SWITCH
1. Discontinue power to the dryer.
2. Open the main door completely.
3. Remove the two (2) Phillips head screws holding the main door switch housing in place.
4. Disconnect the main door switch wires from the switch (two [2] yellow wires).
5. Disassemble door switch by removing the two (2) nuts and washers holding the door switch in place.
6. Reverse this procedure to install new door switch.
IMPORTANT: UNDER NO CIRCUMSTANCES should the door switch be disabled.
IMPORTANT: When reinstalling the door switch housing to the dryer, be sure the internal wires DO
NOT get pinched between the door switch housing and the front panel.
7. Reestablish power to the dryer.
Y. TO REPLACE DIRECT SPARK IGNITION (DSI) MODULE
1. Remove the lint drawer, the control/lint door, and the gas valve train assembly from the dryer (follow Gas
Valve Train Removal Procedure in Section C).
2. Disassemble the DSI module/bracket assembly from the gas valve train slide by removing the two (2) sets
of nuts and washers securing the bracket to the gas valve train.
3. Disconnect ALL wiring to the DSI module including the orange high voltage (HV) lead.
IMPORTANT: Identify the location of each wire for correct reinstallation.
4. Disassemble the DSI module from the bracket by removing the four (4) sets of nuts and washers securing
the DSI module to the bracket.
5. Reverse Step #3 through Step #5 to install the new DSI module.
IMPORTANT: Be sure wires removed in Step #4 are connected to the correct terminal positions.
When connecting the orange high voltage (HV) lead to the DSI module, be sure it is
securely in place.
6. Reinstall the gas valve train, the control/lint door, and the lint drawer removed in Step #2.
7. Reestablish power to the dryer.