Filter
Top Products
9
10. The belt will come out from the front of the dryer between the basket (tumbler) and the wrapper.
11. Reverse procedure to install new belt.
IMPORTANT: Be sure to set the proper belt tension at idler adjustment (follow Belt/Idler Tension
Adjustment Procedure in Section K).
12. Reestablish power to the dryer.
I. TO REMOVE/REPLACE MOTOR
1. Discontinue power to the dryer.
2. Remove the lint drawer and the control/lint door from the dryer (follow Lint Drawer and Control/Lint
Door Removal Procedures in Section A and Section B).
3. If top basket (tumbler) is being serviced, remove the control box from the dryer (follow Control Box
Removal Procedure in Section D).
4. Remove the two (2) 9/16” OD nuts that are on the idler tension spade bolt.
5. Remove the belt from the idler bracket and the motor shaft.
6. Remove the idler bracket; one (1) 1/2” OD bolt in the front and two (2) 1/2” OD bolts on the right side of
the bracket.
7. Loosen the four (4) 1/2” OD nuts that hold the motor to the motor mount. These nuts are at the underside
of the motor mount assembly.
IMPORTANT: DO NOT remove these four (4) bolts.
8. Remove the lower half of the rear split back guard panel to either the top or the bottom basket (tumbler),
depending on which basket (tumbler) is being serviced.
9. Remove the four (4) 7/16” OD nuts, which secure the impellor (fan/blower) cover to the blower housing.
10. Remove the two (2) 7/16” OD nuts and lock washers, which secure the impellor (fan/blower)/shaft bearing
to the impellor (fan/blower) housing cover.
11. Loosen the two (2) setscrews on the impellor (fan/blower)/shaft bearing.
12. Remove the impellor (fan/blower)/shaft bearing from the shaft. To do so, wedge a slotted screwdriver
blade between the bearing and impellor (fan/blower) cover and walk bearing back off shaft. The impellor
(fan/blower) cover will now separate from the impellor (fan/blower) housing.
13. Remove impellor (fan/blower) lock nut (right hand) and lock washer securing impellor (fan/blower) to
motor shaft. This can be done by turning the lock nut to the left with an adjustable wrench, or more
advisable, with a 1-1/8” deep socket ratchet wrench in an effort to avoid damaging the lock nut.