Filter
Top Products
26 American Dryer Corp. 450268-1
TO REPLACE STEAM COIL (DAMPER SYSTEM)
1. Discontinue power to the dryer.
2. Remove the four (4) lock washers and hex nuts securing the hinges to the steam coil.
3. Remove hinges from the steam coil housing (these will be used on the new assembly).
4. Remove six (6) washers and hex nuts securing steam coil to the dryer.
5. Remove the steam coil assembly.
6. Reverse procedure for the new steam coil assembly.
TO REPLACE PISTON
1. Discontinue power to the dryer.
2. Discontinue the air supply to the dryer.
3. Remove left and right piston supports by removing two (2) washers and hex nuts and slide pin out.
4. Remove 1/8” M.P.T. connector from the piston and remove acorn nut on the end of piston shaft (this
will be used on the new piston).
5. Reverse procedure for installing the new piston.