Filter
Top Products
24 American Dryer Corp. 450268-1
TO REPLACE BURNER TUBES
1. Discontinue power to the dryer.
2. Close shutoff valve in the gas supply line.
3. Disconnect the gas valve wiring.
4. Break union connection before gas valve.
5. Loosen and remove two (2) screws
securing the gas valve bracket to the
burner.
6. Remove gas valve/manifold assembly from the dryer.
7. Remove the screws securing the front flanges of the burner tubes to the burner rest.
8. Remove burner tubes by sliding them out.
9. Replace by reversing procedure.
WARNING: Test ALL connections for leaks by brushing with a soapy water solution (liquid
detergent works well).
WARNING: NEVER TEST FOR LEAKS WITH A FLAME!!!
TO REPLACE DIRECT SPARK IGNITION (DSI) MODULE
1. Discontinue power to the dryer.
2. Remove the wires connected to the
terminal strip at the top of the module,
and wires connected on the side of the
module.
3. Remove the high voltage wire from the
module.
4. Remove the two (2) hex nuts securing
the module to the module mounting
bracket.
5. Replace module by reversing process.