Filter
Top Products
450268-1 www.amdry.com 19
TO REPLACE COMPUTER TEMPERATURE SENSOR PROBE
1. Discontinue power to the dryer.
2. Remove microprocessor sensor bracket assembly
from the dryer.
a. Disconnect sensor bracket harness connector.
b. Loosen the two (2) Phillips head screws securing
the bracket assembly to the dryer and remove the
bracket from the dryer.
NOTE:
DO NOT
remove screws.
3. Disassemble the sensor probe from the bracket assembly by removing the top push on fastener
securing the probe to the bracket. Use a small screwdriver to slowly pry the fastener off.
4. Disconnect the two (2) orange wires from the high heat (225º) temperature thermostat. Remove
modular bracket connector, wires, and probe from the bracket assembly.
5. Install new sensor probe assembly (ADC Part No. 880251) by reversing the procedure.
6. Reestablish power to dryer.
NOTE: If, when power is reestablished the computer display reads “dSFL”, check for loose
connection on the wiring.
TO REPLACE MOTOR CONTACTOR 3-POLE, 24 VAC
1. Discontinue power to the dryer.
2. Remove ALL wires from contactor (NOTE: make sure each wire is marked with location removed
from).
3. Press down firmly on the contactor and shift towards the right, then pull contactor out.
4. Install the new contactor in reverse procedure.
5. Reestablish power to the dryer.