Filter
Top Products
Table of Contents _______
Proposition 65
Use of this product could expose you to substances
from fuel combustion that contain chemicals
known to the State of California to cause cancer,
birth defects and other reproductive harm.
▲ WARNING
!
IMPORTANT
You must disconnect and lockout the electric supply
and the gas supply or the steam supply before any
covers or guards are removed from the machine to
allow access for cleaning, adjusting, installation, or
testing of any equipment per OSHA standards.
Please observe all safety precautions displayed on
the equipment and/or specified in the installation
manual included with the dryer.
Before installation, check that the local distribution
conditions, nature of gas and pressure, and
adjustment of the appliances are compatible.
CAUTION
Dryer(s) should never be left unattended while in
operation.
When discarding or storing your old clothes dryer,
remove the door.
Lorsque vous entreposez ou mettez votre
sécheuse au rebut, enlevez-en la porte.
“Caution: Label all wires prior to disconnection when
servicing controls. Wiring errors can cause improper
operation.”
«Attention: Au moment de l’entretien des commandes,
étiquetez tous les fils avant de les débrancher. Des
erreurs de câblage peuvent entraîner un
fonctionnement inadéquat et dangereux.»
WARNING
Children should not be allowed to play on or near the
dryer(s). Children should be supervised if near
dryer(s) in operation.
Under no circumstances should the dryer door
switch(es), lint door/drawer switch(es), or heat safety
circuit(s) ever be disabled.
The dryer must never be operated with any of the
back guards, outer tops, or service panels removed.
Personal injury or fire could result.
The dryer must never be operated without the lint filter/
screen in place, even if an external lint collection
system is used.
FOR YOUR SAFETY
Do not dry mop heads in the dryer. Do not use
dryer in the presence of dry cleaning fumes.
The dryers must not be installed or stored in an
area where it will be exposed to water and/or
weather.
The wiring diagram for the dryer is located in the
front electrical control box area.
List of Acronyms ____________________
D.M.S. Drill Measurement Size
DSI Direct Spark Ignition
HVAC Heating, Ventilating, and Air-Conditioning
in WC Inches of Water Column
L.C.D. Liquid Crystal Display
L.E.D. Light Emitting Diode
L.P. Liquid Propane
OSHA Occupational Safety and Health Administration
R.M.A. Return Material Authorization
S.A.F.E. Sensor Activated Fire Extinguishing
UL Underwriters Laboratory
Safety Precautions ................................... 4
Specifications ........................................... 6
Installation Procedures ............................ 8
Unpacking/Setting Up ................................................. 8
Location Requirements .............................................. 8
Dryer Enclosure Requirements .................................. 8
Fresh Air Supply Requirements .................................9
Exhaust Requirements ...............................................9
Electrical Information ................................................12
Gas Information ........................................................15
Steam Information ....................................................17
Preparation for Operation/Start-Up ..........................19
Preoperational Test ...................................................20
Preoperational Instructions ......................................20
Shutdown Instructions ..............................................21
Service/Parts Information ...................... 22
Service ......................................................................22
Parts ..........................................................................22
Warranty Information ............................. 22
Returning Warranty Cards........................................ 22
Warranty ...................................................................22
Returning Warranty Parts ......................................... 22
Routine Maintenance.............................. 23
Cleaning ....................................................................23
Adjustments ..............................................................23
Lubrication ................................................................23
Data Label Information........................... 24
Procedure for Functional Check
of Replacement Components ................. 24
Manual Reset
Burner Hi-Limit Instructions .................. 26
Phase 7 ..................................................................... 26
Mechanical Timer ......................................................26
S.A.F.E. System ....................................... 26