Filter
Top Products
113237-4 www.amdry.com 21
!
Mechanical Drop/Rotary Coin Meter
or Slide Coin Meter
Insert coin and turn knob (rotary type meter), or for slide meter
unit, push in coin chute.
Select temperature.
Push the “Start” button.
To stop dryer, open the main door.
Non-Coin Models
The L.E.D. display reads “Ready” (no cycle in progress).
Press the letter on the keypad corresponding to the cycle
desired (i.e., key “D”).
Note
“0-40” will require the “Start/Enter” key to be
pressed after the number is selected in order to
accept the selection and start drying.
The dryer will then start. (I.E., blower, tumbler, and heat.)
The L.E.D. display will read MANUAL DRYING CYCLE D,
00:00 MIN REMAIN.
Note
Press and hold the “Up Arrow” to view the tumbler
temperature at any time.
The dryer can be stopped at any time by pressing the
“Stop/Clear” key, at this time the dryer will go into a cycle
pause. If the “Stop/Clear” key is pressed again at this point,
the cycle that was in progress will be cancelled and
returned to the “Ready” state.
Press and hold the “Down Arrow” to view the tumbler RPM.
When the programmed drying time has expired, the Phase 7
non-coin microprocessor controller (computer) will proceed
into the Cool Down Cycle.
Once the Cool Down Cycle begins at the end of the heat cycle,
the L.E.D. display will read COOL DOWN TEMP ___/___
MINUTES remaining. At the end of the heat cycle, the dryer
will shut off the heat and continue the fan and tumbler until
the Cool Down Time or temperature is reached.
Important
For more detailed information regarding the
microprocessor controller (computer) on your
dryer, refer to the microprocessor user’s manual included
with the dryer.
Dual Timer Dryers
Turn drying timer knob for a time of 20 minutes.
Select “High Temp”.
Push “Push to Start” button.
To stop dryer, open the main door.
Spin and dwell (stop) times are adjustable at the reversing
timer.
!
!
DNEGELGNIMIT
EMITNIPS
rebmuNnoitisoPtnemtsujdA12345
sdnoceSniemiT * 030609021051
EMIT)POTS(LLEWD
rebmuNnoitisoPtnemtsujdA12345
sdnoceSniemiT * 53.66.79.82.01
.dnoces-1-/+eranwohsseulaV*
Reversing Timer Spin/Dwell Adjustments
Timer models have an electronic reversing timer in the
electrical service box, which is located in the upper left rear
area of the dryer.
Both the dwell (stop) time and the tumbler spin time are
adjustable by mode selection switches located on the
electronic timer (as noted in the illustration below).
Shutdown Instructions ________________
If the dryer is to be shutdown (taken out of service) for a period
of time, the following must be performed:
Discontinue power to the dryer either at the external disconnect
switch or the circuit breaker.
Discontinue the heat supply.
Gas Models – discontinue the gas supply.
Shut off external (location furnished) gas supply shutoff valve.
Steam Models – discontinue the steam supply.
Shut off external (location furnished) shutoff valve.