Filter
Top Products
450268-1 www.amdry.com 45
BURNER PURGE FAULT – The gas valve signal is present during the prepurge time.
MODEL ERROR, ENTER CORRECT MODEL – The wrong model was selected for the dryer.
EE PROM FAULT ### – Error in memory location. The ### indicates the location of the fault.
B. INPUT/OUTPUT BOARD LIGHT EMITTING DIODE (L.E.D.) INDICATORS
1. Inputs (Red L.E.D.)
1. ESTOP – This L.E.D. will indicate the status of the E-STOP. If the E-STOP has been pressed, then
the L.E.D. is on.
2. GAS_V – This L.E.D. will indicate the status of the gas valve. If the gas valve is open (ON), then the
L.E.D. is on.
3. BRHL – This L.E.D. will indicate the status of the burner high limit disk. If the disk is closed (temperature
below 330º F [166º C]), then the L.E.D. is ON.
4. SAIL – This L.E.D. will indicate the status of the sail switch. If the switch is closed, then the L.E.D. is
ON.
5. EXHL – This L.E.D. will indicate the status of the exhaust high limit disk. If the disk is closed
(temperature below 225º F [107º C]), then the L.E.D. is ON.
6. MAIN – This L.E.D. will indicate the status of the main door. If the door is closed, then the L.E.D. is
ON.
7. LINT – This L.E.D. will indicate the status of the lint drawer. If the drawer is closed, then the L.E.D.
is ON.
8. FUSE – This L.E.D. will indicate the status of the control voltage. If the POWER ON button is
pressed (green button light is on), then the L.E.D. is ON.