Filter
Top Products
450268-1 www.amdry.com 31
TO ADJUST SAIL SWITCH
1. Operate the installed dryer normally to verify that the heat system is fully operational.
2. Open the main dryer door.
3. Manually depress the door switch actuator.
4. While continuing to depress the door switch actuator, and with the door open, start the dryer.
5. If the heat system is not activated in 15-seconds, the sail switch is properly adjusted.
6. If the heat system is activated, the sail switch is improperly adjusted and must be readjusted by
bending the actuator arm of the sail switch toward the front of the dryer. If the actuator arm is bent
too far toward the front of the dryer, the dryer may not have heat when needed. After any adjustments
of the sail switch, the above procedure must be repeated to verify proper operation.
CAUTION:
DO NOT
disable this switch by taping or screwing sail switch damper to burner.
Personal injury or fire could result.
G. FRONT PANEL AND MAIN DOOR ASSEMBLIES
TO REPLACE MAIN DOOR SWITCH
1. Discontinue power to the dryer.
2. Open the main door.
3. Remove the two (2) Phillips head screws holding the main
door switch cover in place.
4. Remove the two (2) nuts and washers securing the switch
to the door hinge, and take the switch off the two (2) clinch
studs on the hinge.
5. Disconnect the two (2) wires on the door switch. Connect
the new door switch to those two (2) wires.
6. Reverse this procedure for installing the new door switch.
IMPORTANT: UNDER NO CIRCUMSTANCES should the door switch be disabled.