Filter
Top Products
450268-1 www.amdry.com 17
SECTION V
SERVICING
IMPORTANT: YOU MUST DISCONNECT AND LOCKOUT THE ELECTRIC SUPPLY AND
THE GAS SUPPLY BEFORE ANY COVERS OR GUARDS ARE REMOVED
FROM THE MACHINE TO ALLOW ACCESS FOR CLEANING,
ADJUSTING, INSTALLATION, OR TESTING OF ANY EQUIPMENT PER
OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION (OSHA)
STANDARDS.
WARNING: PERSONAL INJURY COULD RESULT.
The information provided in this section should not be misconstrued as a device for use by untrained
persons making repairs. Service work should be performed by competent technicians in accordance
with local, state, and federal codes. When contacting the factory for assistance, always have the dryer
model number and serial number available.
CAUTION: Observe ALL safety precautions displayed on the dryer or specified in this
manual before and while making repairs.
Before considering replacement, make sure that ALL connectors are in place and making proper contact.
Check input voltages and temperature sensor. After replacing any parts, or performing adjustments or
service, run through a complete cycle.
A. CONTROLS (COMPUTER)
TO REPLACE CONTROL PANEL ASSEMBLY
1. Disconnect power to the dryer.
2. Disconnect the J3, J4, J5, J6, and J8
harnesses from rear of the computer by
squeezing the top locking tabs and
pulling the connector straight back.
3. Disconnect the green ground wire from
the computer.
4. To remove control panel assembly from the control box, gently tap the bottom of the control panel
upward and lift off the hinges.
5. Install new control panel assembly by reversing the procedure.
6. Be sure to check or reset programs.
NOTE: Use caution when handling microprocessor controller. It can be easily damaged by
static electricity.