Filter
Top Products
450268-1 www.amdry.com 41
TO REPLACE V-BELTS
1. Loosen tension on V-belts, so that they can easily be rolled off pulleys.
2. Replace V-belts.
3. Retighten V-belts and adjust tension and alignment per previous instructions.
M. MOTOR
TO REPLACE MOTOR (NON-REVERSING)
1. Discontinue power to the dryer.
2. Remove the drive belt.
3. Disconnect wiring harness from the motor.
4. Remove nuts and washers holding the motor mount to the rear of the dryer and pull motor mount
away.
5. Remove the two (2) left hand nuts on the motor shaft securing the impellor. Work the impellor free
from the motor shaft by means of a puller, to prevent damage to the motor shaft.
6. Remove the bolts holding the motor to the motor mount and replace it with a new motor.
7. Remove pulley from the old motor and install on the new motor.
8. Align motor with impellor face in plane with the motor mount at no less than 3/16” clearance.
9. Replace motor mount to the dryer.
N. IMPELLOR
NOTE: Follow
Steps #1 through #5 and #8
in “Section V, Part M.”