Filter
Top Products
28 American Dryer Corp. 450268-1
D. ELECTRICAL OVEN CONTROLS
TO REPLACE ELECTRICAL ELEMENTS
1. Discontinue power to the dryer.
2. Remove cover by removing two (2) screws and
lifting the cover.
3. Remove the screws and wiring holding the
element in place at the rear of the oven.
4. From the front of the oven, slide out element.
5. Reverse procedure for installation of new
element.
TO REPLACE OVEN CONTACTOR
1. Discontinue power to the dryer.
2. Remove wiring from contactor.
3. Remove three (3) nuts and lug nuts from the studs.
4. Pull contactor off.
5. Reverse procedure for installing new contactor.