Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
802702
46
Reinstallation of Shipping Materials
To prevent damage while moving the unit, the
shipping materials MUST be reinstalled.
Disconnect washer from electrical supply.
While supporting the front access panel, remove
two screws from the bottom edge of the panel.
Gently lower the panel to remove it from the
washer.
Place the shock sleeves on all four shock
absorbers. Refer to Figure 66.
Insert hooked end of shipping brace into the open
slot of the motor mount.
Attach the brace with the five bolts and washers.
Refer to the illustration below.
Reinstall front access panel.
Figure 66
Refer to Installation section, Step 9, for proper
procedures whenever the washer is moved.
Motor Overload Protector
The dryer’s motor overload protector stops the motor
automatically in the event of an overload. After
cooling, the overload protector will reset itself. Dryer
can be restarted by pressing the START pad. If
overload protector cycles again, remove the dryer
from use and call the service person to correct the
problem.
For Energy Conservation
Make sure the lint filter is always clean.
Do not overload dryer.
Do not overdry clothes.
Remove items to be ironed while still damp.
Large loads of similar fabrics dry the most
efficiently. However, dry permanent press in
smaller loads to prevent wrinkling.
Use the correct temperature FABRIC
SELECTOR setting for the type of fabric being
dried.
Locate your dryer so the exhaust duct is as short
and straight as possible.
Do not open the door during the drying cycle.
Plan to do your laundry on low humidity days;
your clothes will dry faster.
Should you plan to dry several loads, do them
one after another, then you do not have to reheat
the dryer unit’s interior parts each time.
FLW2124N
1 Shock Sleeves
2 Motor Mount
3 Hooked End of Shipping Brace
4 Bolts and Lockwashers
FLW2124N
2
1
4
3