Filter
Top Products
Programming
F232090
36
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming Heat
1. To program auxiliary heat (either electric or
steam), the computer must be in the PROGRAM
mode, and the cycle programming sequence must
be ready for the next step.
NOTE: Models with both electric and steam heat
are equipped with a selector switch which allows
the user to select either option. Because both
options are energized by the WE-6 computer via
the same output, the procedure for programming a
heat step will be the same for either. The switch
directs the output signal only to the selected option.
2. The machine must be filled with water.
3. Press the Heat key. The display will read
“HTnncc,” with “nn” representing the step
number and “cc” representing the cycle number.
4. Press the Enter key. The display will read either
“080Fnn” or “025Cnn,” depending on whether
Fahrenheit or Centigrade is prompted.
5. Enter the final temperature desired. Three digits
must be entered for the temperature. If the
desired temperature is less than 100 degrees, the
first digit should be “0.” The valid temperature
range is 80–200 degrees Fahrenheit and 25–93
degrees Centigrade. The computer will not
accept temperatures outside of this range. If 100
degrees Fahrenheit is selected, the display will
read “100Fcc.”
6. Press the Enter key. The display will read
“H---M.” Now assign the maximum time in
hours and minutes for the water to reach the
desired temperature.
7. Press the Enter key and go to the next step in the
cycle.
Programming a Wash Step
1. The computer must be in the PROGRAM mode,
and the cycle programming sequence must be
ready for the next step.
2. Press the Wash key. The display will read
“Wnncc.”
3. Now press the number key (from 1 to 5) that
corresponds to the desired wash step listed in the
following table:
4. If Wash 1 is chosen, the no-reverse option may be
selected. The no-reverse option must be selected
at this point in the step programming. Press the
No Reverse key while the display reads
“W1nncc.”
When the no-reverse option is selected, the
display will change, but the machine will follow
the programming command.
The no-reverse option will cause the basket to
run forward only at wash speed for the time
programmed. The computer will return to normal
reversing action when this step is complete.
The no-reverse option may be programmed in
wash, supply, heat, and overflow steps. The No
Reverse key must be pressed just prior to
pressing the Enter key when programming a
step.
5. Press the Enter key, and the display will read
“M---S.” Now assign the wash step time in
minutes and seconds.
6. Press the Enter key and go to the next step in the
cycle.
7. On machines equipped with optional auxiliary
heat (steam or electric), it is possible to program
a wash step with a temperature step. During such
a step, the machine will perform the programmed
wash at the temperature programmed,
maintaining that temperature throughout the step.
To program a wash with a specific temperature,
use the following procedure:
a. After step 3 of Programming a Wash Step,
press the Heat key before pressing the Enter
key. The display will read either “080Fcc” or
“025Ccc,” depending on whether Fahrenheit
or Centigrade is prompted.
Wash Description
1 12 seconds forward, pause 3seconds,
12 seconds reverse, pause 3 seconds; repeat
2 3 seconds forward, pause 12 seconds,
3 seconds reverse, pause 12 seconds, repeat
3 No agitation
4 Distribution speed (forward only)
5 See Programming a Wash 5 Thermal
Cool-down. Agitation is the same as Wash 1.