Filter
Top Products
Programming
F232090
30
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
System Programming
Prompting the WE-6
Prompting the WE-6 allows:
● Displaying sump temperature in Centigrade or
Fahrenheit.
● Recognizing and controlling one or two
independent drains. (Two independent drains will
apply only for special applications.)
● Enabling or disabling the Advance key in the
RUN mode.
● Enabling or disabling the manual mode.
● Controlling the Auxiliary 1 output for use with
liquid supplies.
● Reading or resetting the cycle count.
To begin prompting the computer, insert key into the
program mode switch (located on the left side of the
control module) and turn key to the PROGRAM
position. The display will read “CYC00.”
1. Press the Auxiliary key, key 2, and key 9 in that
order. The display will read either “CEN”
(Centigrade) or “FAR” (Fahrenheit). To choose
the alternate feature, press key 0.
2. Press the Enter key. The display will read either
“1DRAIN” or “2DRAIN.” The normal prompt
for most applications is “1DRAIN.” “2DRAIN”
is used only for special applications. Consult the
factory for full details. To choose the alternate
feature, press key 0.
3. Press the Enter key. The display will read either
“ADV” or “NO ADV.” The prompt “NO ADV”
will disable the Advance key in the RUN mode,
thereby preventing the operator from advancing
the computer through steps of the cycle before
they are complete; also, it will not be possible to
advance to any step before starting a cycle if “NO
ADV” is selected. To choose the alternate
feature, press key 0.
4. Press the Enter key. The display will read either
“MANUAL” or “NO MAN.” If “MANUAL” is
displayed, the manual mode will be enabled
during normal operation. If “NO MAN is
displayed, the manual mode will be disabled
when a cycle is run, even if the Manual
operation key sequence is entered. To choose the
alternate feature, press key 0.
5. Press the Enter key. The display will read either
“D SUPP” or “L SUPP.” “D SUPP” indicates that
the WE-6 is prompted for dry supplies, in which
case only the programmed supply combination
energizes during a supply step. “L SUPP”
indicates that the WE-6 is prompted for liquid
supplies. In this case, the Auxiliary 1 output
energizes along with the programmed supply
output(s) during a supply step. In the manual
mode, “AUX 1” must be manually energized if
desired with manually selected supplies.
6. Press the Enter key. The display will show
“USEDxx.” (The “xx” here stands for the
number of cycles run and will be represented by
numbers in the actual display.)
The count can be left as it appears in the display,
or it can be reset to “00.”
● To leave the count unaltered, press the Enter
key to return to the normal programming
mode.
● To reset the count, press key 0. The display
will read “USED00.”
Press the Enter key to return to the normal
programming mode.
The computer stores the cycle count in RAM.
Thus, if power to the computer is interrupted, the
count will automatically be set at “00.”
If a daily count is desired, the display should be
read at the end of the day and then reset prior to
running the next day’s first cycle. (The display
resets automatically after the cycle count reaches
99.)
7. Return the program mode switch to the RUN
position and remove the key. Prompting is
complete.
NOTE: Prompting will change the parameters in
all cycles programmed.