Alliance Laundry Systems UC35 Washer User Manual


 
31
Installation
F232062
Mechanical Installation
This subsection provides four specific methods
of mechanical installation. Follow the
procedure most appropriate for your machine.
Note:
Improper installation may void the
warranty. Consult the manufacturer or your
distributor before deviating from the
appropriate procedure.
Expansion Bolt Installation
(2-Speed Models Only)
Note:
Expansion bolts are not suitable
for 3-speed or variable-speed machine
installations. Expansion bolts should not be
used in single-machine concrete foundation
pad installations.
Use the following instructions and Figures
15 through 20 as a step-by-step guide
to installation of the expansion bolts.
1. Verify that the floor is 3500 psi minimum
reinforced concrete embedded in clean,
compacted fill dirt and at least 4 inches
(102 mm) thick.
2. Verify that the mounting surface is level
and even. If the mounting surface fails to
meet these requirements, the machine
must be installed using J-bolts and
machinery grout.
3. Use the base of the machine as a template
by positioning the machine in the desired
location and marking the pre-drilled
mounting holes on the floor. See
Figure 15.
Figure 15
4. Set the drill depth gauge to 2-9/16 inches
(65 mm). See Figure 16.
Figure 16
5. Drill the holes to the set depth. See
Figure 17.
Figure 17
H025I
H026I
H027I