Filter
Top Products
27
Installation
F232062
Dimensional Clearances
Allow a minimum of 12 inches (305 mm) at
the rear for 18-pound and 25-pound capacity
models and a minimum of 18 inches (457 mm)
at the rear for the larger machines. Allow
2 inches (51mm) at the sides and 1 inch
(25 mm) between machines in multiple
installations. Dimensional clearances are
indicated in Figures 9 through 14 for each size
of machine, starting with the 18-pound model
and finishing with the 80-pound model.
Note:
The dimensional clearances for the
80-pound model are dependent upon which set
of mounting bolt holes is used. If the machine
is intended for close mounting (mounting bolt
pattern labeled "A" in Figure 28), follow the
clearances in Figure 14. If the machine is
intended for standard mounting (mounting bolt
pattern labeled "B" in Figure 28), provide a
minimum clearance of 8 inches (203 mm) at
each side of the machine in addition to the
clearances in Figure 14.
Figure 9
Figure 10
H019IE1A
18-Pound Capacity Machines
H020IE1A
25-Pound Capacity Machines