Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
17
F8112201
3. Verify V-belts are properly aligned by checking
pulley alignment. Place a straight edge across
both pulley faces. The straight edge should make
contact with pulleys in two places. Refer to
Figure 4.
Figure 4
4. Remove back panel and check all hoses for leaks,
cracking and deterioration.
5. Open machine top cover and check supply
dispenser hoses and hose connections for leaks.
6. Remove front service panel. Check all hoses and
temperature probe for leaks, cracking and
deterioration.
7. Clean inlet hose filter screens:
a. Turn water off and allow valve to cool, if
necessary.
b. Unscrew inlet hose and remove filter screen.
c. Clean with soapy water and reinstall. Replace
if worn or damaged.
8. Make sure that all hose clamps are tight and all
hoses are secure
9. Tighten motor mounting bolt locknuts and
bearing bolt locknuts, if necessary.
10. Verify that motor plate mounting bolt is tight but
plate is free to pivot.
11. Use compressed air to clean dust and lint from
motor.
12. Clean interior of washer-extractor, both basket
and shell, by wiping with a water-soaked sponge
or cloth.
13. Open rear electrical enclosure and clean out any
dust or lint build up in box with a vacuum cleaner
and a soft brush. Lint build-up can result in a fire
hazard.
14. Remove chemical supply components and check
for residual chemicals. Clean as necessary and
replace.
P045I
1 Drive Motor
2 Drive Pulley
3 Belt
4 Straight Edge
5 Drive Pulley
1
2
3
4
5
Do not clean the cooling fans with
compressed air! Doing this spins the fan
too fast and will cause premature fan
failures.
W695
WARNING