Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
13
F8112201
Clearing an Alarm:
1. Note alarm code flashing on program display in
order to look it up and correct problem.
2. Press ENTER button and display will be cleared.
PS40 control will continue running normally.
An alarm code indicates a potential machine problem
or condition that should be examined.
Clearing a Fault:
1. Note fault code flashing on program display in
order to look it up and explain problem to a
qualified technician.
2. Wait until machine has stopped and door is
unlocked.
3. Open door.
4. Press E-Stop button or disconnect main electrical
service to machine.
5. Call a qualified service technician.
6. When power is restored fault will be cleared and
PS40 control will attempt to run again.
Tips:
• Always try to load machine as fully as possible.
Small loads are generally harder on any front
loading washer and cannot be processed as
efficiently. They use more water per pound and
more electrical energy.
• Use appropriate low sudsing detergents and
chemicals.
• If a power failure interrupts machine during a
program, program can be resumed where it was
interrupted when power is restored by pressing
START button on control.
• To add goods after a program has been started,
press STOP button. After machine has drained
and is safe, it will unlock door. Open door and
add additional goods to be processed. Close door
and press START button to restart program where
it left off.
• If wrong program number is accidentally entered,
control will allow you to reenter it and change
program being run for up to 3 minutes.
The PS40’s fault codes indicate potentially
hazardous operating conditions. If a Fault
occurs the machine should be shut off
and locked out until a service technician
can repair the machine. All fault codes are
indicated by a flashing “Fn” display.
Where F indicates a fault condition, and n
indicates the particular fault number.
W687
WARNING