Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
F8112201
16
Monthly
NOTE: Disconnect power to washer-extractor at its
source before performing monthly maintenance
procedures.
Keep the following lubricants on hand for periodic
maintenance of machine.
1. Each month or after 200 hours of operation,
lubricate bearings using grease fittings located in
upper rear panel. Pump grease gun slowly, using
full strokes. Use the following schedule to
determine number of strokes to use for machine.
The grease must have the following
characteristics:
• NLGI Grade 2
(Recommended: Shell Alvania
®
#71125)
• Lithium-based
• Water-insoluble
• Anti-rusting
• Anti-oxidizing
• Mechanically stable
The grease must have adequate base oil viscosity
with one of the following ratings:
• ISO VG 150 (135 – 165 cSt at 40°C or
709 – 871 SUS at 100°F)
• ISO VG 220 (198 – 242 cSt at 40°C or
1047 – 1283 SUS at 100°F)
• An SAE 40 rating is also acceptable as long as
cSt or SUS values are within specified ranges.
If machine is fitted with SKF System 24
®
automatic
lubricators, check that they are functioning by noting
piston position each month. Set them to dispense their
contents over 12 months for all machine models.
Always mark new lubricators with installation date.
2. Remove rear service panel and inspect drive belts
for uneven wear, frayed edges or cracking. Push
on belts and make sure motor can move about its
pivot point (this ensures belts are automatically
being tensioned correctly).
Main
Bearings
Shell Alvania
®
71125 Grease
Motor
Motor bearings are sealed and do not
require service.
Door
Latch
Silicon Spray Grease
Door
Handle
Silicon Spray Grease
Machine
type
Number of strokes per
month or 200 hours of
operation
Front
Bearing
Rear
Bearing
40M, 60M 2 1
40H, 60H, 80M, 100M 2 2
80H, 100H, 125H, 140M 3 2
140H, 175H 4 2
Never mix grease types (Ex. Silicon,
Petroleum, Lithium, Poly-Urea)! Never use
any grease other than that specified at the
grease fittings on the machine. Doing so
may cause premature bearing failure and
void any applicable warranties.
W694
WARNING