Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
F8112201
12
General Operation Instructions
1. Make sure machine has been installed properly
and that water and electrical services are on.
2. Sort laundry according to care labels, type, etc.
3. Open door and make sure that machine is empty.
4. Load goods to be processed into drum.
5. Close and lock door securely by pushing in on
door handle – it should click twice.
6. Open supply dispenser, slide out dispenser cups
one at a time and fill with appropriate chemicals.
Replace cups.
7. Close supply dispenser door.
8. Enter number of desired program. Refer to
Operating PS40 Control section. Programs 0 – 9
have been preprogrammed at factory for typical
conditions. Preprogrammed formulas may vary,
so a Programming Manual will be provided to
document preprogrammed formulas.
9. Press START button on control.
10. Machine door will automatically lock and
selected formula will be executed.
11. When program is completed, display will show
message “open door” and door will automatically
be unlocked.
12. Open door by pushing door release panel and
remove all goods.
Operating PS40 Control
Running a Program:
1. Make sure loading door is closed and locked.
2. Enter 2 digit program number corresponding to
desired program.
3. Press START button.
Stopping a Program:
1. Press STOP button and wait for door to be
unlocked.
2. Open loading door.
3. Close loading door.
4. Press STOP button – program will be aborted.
5. Open and close loading door again and program
will be cleared and aborted. Display will return to
“Start”.
Fast Advancing a Program:
1. Press and hold ENTER button and program time
will advance.
2. When program time pauses, release ENTER
button. To continue to end of program, continue
holding ENTER button.
When PS40 Control fast advances it will pause
whenever it comes to beginning of a drain or agitation
routine.
Display bath temperature and cylinder speed:
1. Press TEMPERATURE/TOGGLE button and
current temperature is displayed.
2. Press TEMPERATURE/TOGGLE button again
and target temperature is displayed.
3. Press TEMPERATURE/TOGGLE button again
and current cylinder RPM is displayed.
4. Display will revert to program status display after
a few seconds.
Never use flammable materials of any kind
in the machine! Never use any solvent
other than water!
W686
WARNING