Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
15
F8112201
Daily
Beginning of Day
1. Inspect water inlet valve hose connections on
back of washer-extractor for leaks, cracking or
other deterioration.
2. Inspect steam hose connections for leaks,
cracking or other deterioration (where
applicable).
3. Check electrical service connections at back of
machine. Make sure they are secure and that
there is no deterioration or cracking of insulation.
If there are any exposed bare conductors or
damaged insulation, call a service technician.
4. Check door interlock before starting operation:
a. Attempt to start with door open. Machine
should not start with door open.
b. Close door without locking it and attempt to
start. Machine should not start with door
unlocked.
c. Close and lock door and start a cycle. Attempt
to open door while cycle is in progress. Door
should not open.
If door interlock failed any of the above tests, do
not operate machine. Call a service technician.
End of Day
1. Clean AC drive filter:
a. Snap off external plastic cover which contains
filter.
b. Remove foam filter from cover.
c. Wash filter with warm water and allow to air
dry. Filter can be vacuumed clean.
2. Clean door gasket of residual detergent and all
foreign matter.
3. Clean automatic supply dispenser and lid inside
and out with mild detergent. Rinse with clean
water.
4. Clean powder dispenser and lid with mild
detergent. Rinse with clean water.
5. Clean machine’s top, front and side panels with
mild detergent. Rinse with clean water.
6. Leave loading door open at end of each day to
allow moisture to evaporate.
NOTE: Unload washer-extractor promptly after
each completed cycle to prevent moisture buildup.
Leave loading door open at end of each completed
cycle to allow moisture to evaporate.
Weekly
1. Check washer-extractor for leaks.
a. Start an unloaded cycle to fill washer-
extractor.
b. Verify that door and door gasket do not leak.
c. Verify that drain valve is operating and that
drain system is free from obstruction. If water
does not leak out during prewash segment,
drain valve is closed and functioning properly.
2. Inspect floor around machine for water indicating
an internal leak.
To reduce the risk of electrical shock,
serious injury or death, disconnect the
electrical power to washer-extractor before
examining the wiring.
W636
WARNING