Filter
Top Products
Operation
13
F232088
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Start-up
Switch the ON/OFF rocker switch on the control
module to the ON position.
Opening Door
Use left hand to press and hold the door unlock button
located on the lower right front of the control panel.
Use right hand to turn door handle clockwise and
swing the door left to open. See Figure 3.
Figure 3
The door will not open if the timer pointer is not in the
vertical position at the top of the dial. If the pointer is
not vertical, the timer must be rapid-advanced until the
timer pointer is in the vertical position. The rapid-
advance procedure is as follows:
1. Press and hold the START button. The timer will
begin rapid-advancing through the cycle.
2. Release the START button when the timer stops
advancing.
3. Wait one minute.
4. The door unlock button will be enabled, allowing
the door to be opened.
Loading
Load the machine to full capacity whenever possible,
but do not exceed the rated dry-weight capacity of the
machine if the fabric to be washed is quite dense,
closely woven, and heavily soiled. Overloading can
result in an inferior wash. The operator may need to
experiment to determine load size based on fabric
content, soil content, and level of cleanliness required.
Partial loads are a waste of energy, water, and
chemicals, and cause greater machine wear than full
loads. Partial loads also increase the possibility of a
severe out-of-balance condition.
When loading is complete, ensure that all fabric is
inside the basket. Then close and lock the door. The
machine should not start or run unless the door is both
closed and locked.
NOTE: When washing items which may
disintegrate or fragment, such as mop heads or
sponges, use laundry nets to prevent drain
blockage.
MD004J
Be careful around the open door,
particularly when loading from a level
below the door. Impact with door edges
can cause personal injury.
SW025
CAUTION
Never operate the machine with a
bypassed or disconnected out-of-balance
switch. Operating the machine with
severe out-of-balance loads could result
in personal injury and serious equipment
damage.
SW010
WARNING
Check the door safety interlock daily
before the machine is placed in operation.
SW024
CAUTION