Filter
Top Products
504523 21
Dryer Exhaust Requirements . . .
Never install flexible duct in concealed spaces, such as a
wall or ceiling.
Exhaust System Materials
Exhaust system materials are not supplied with the dryer.
Exhaust duct must be 10.2 cm (four inches) in
diameter having no obstructions. Rigid metal duct is
recommended. Non-combustible semi-rigid flexible
metal duct is acceptable. Do not use plastic pipe or
flexible plastic pipe, because it contributes to poor drying
performance and collects lint, which can lead to a fire
hazard.
DO NOT use sheet metal screws on exhaust pipe joints or
other fastening means which extend into the duct that
could catch lint and reduce the efficiency of the exhaust
system. Secure all joints with duct tape.
NOTE: Kits described above are optional exhaust
system materials available at extra cost.
A clothes dryer produces combustible lint. To
reduce the risk of fire and combustion gas
accumulation the dryer MUST be exhausted
to the outdoors.
W116
This gas appliance contains or produces a
chemical or chemicals which can cause
death or serious illness and which are known
to the State of California to cause cancer,
birth defects, or other reproductive harm. To
reduce the risk from substances in the fuel or
from fuel combustion, make sure this
appliance is installed, operated, and
maintained according to the instructions in
this manual.
W115
To reduce the risk of fire and the
accumulation of combustion gases, DO NOT
exhaust dryer air into a window well, gas
vent, chimney or enclosed, unventilated area,
such as an attic, wall, ceiling, crawl space
under a building or concealed space of a
building.
W045
To reduce the risk of fire, DO NOT use plastic
pipe or flexible plastic pipe to exhaust the
dryer.
W041
WARNING
DESCRIPTION KIT P/N
MAY BE
OBTAINED
LOCALLY
Exhaust Duct (4" Dia.) Not Available Yes
Flexible Metal Duct (4" Dia) 521P3 Yes
Weather Hoods, with hinged
dampers (4")
Not Available Yes
Directional Exhaust Kit 528P3 No
Tape Not Available Yes
DO
D333IE0B
DON’T
D335IE0A