Filter
Top Products
Installation and connection instructions
44
Compensate for floor unevenness
Floor unevenness can be compensated for and the height can be cor-
rected with the four adjustable screw feet. The height can be adjusted
in the range +10 .. -5mm.
To adjust the feet use the special spanner supplied for removing the
transport braces.
0 1. Slide the special key firmly onto
the hexagon head of the threa-
ded foot as far as it will go.
2. Adjust the screw feet so that the
unit is horizontal and stable. The
unit must not wobble over when
loaded.
3. If necessary, check the setting
with a spirit level.
Important! Minor unevenness of
the floor surface should never be
levelled out by laying pieces of
wood, card or similar materials,
but rather should always be com-
pensated for by adjusting the adjustable feet.