Filter
Top Products
Operating Instructions
32
Water is not running.
The fault code E10 ap-
pears. The display
+Á (RINSE+) flashes.
Water valve closed. Open the water valve.
Filter in screw connection of
the intake hose blocked.
Close the water valve. Un-
screw the hose from the tap,
remove the sieve and clean
under running water
Water tap is blocked with
limescale or is faulty.
Check water tap and have it
repaired if necessary.
The washing machine
vibrates during opera-
tion or it is on an une-
ven surface.
The transport packaging has
not been removed.
Remove transport packaging
according to the installation
and connection instructions.
The height-adjustable screw
feet are not correctly set.
Adjust the feet according to
the installation and connec-
tion instructions.
There is not much washing in
the drum (e.g. only one
dressing gown).
This does not impair the op-
eration of the machine.
The water could not be com-
pletely pumped off before
spinning because
The drainage hose is bent or
The solution pump is
blokked.
Check the laying of the
drainage hose and eliminate
the bend if necessary, or
clean the solution pump and,
if required, remove foreign
bodies from the pump hous-
ing.
The washing solution
of the main wash
froths up a lot.
Too much detergent was
probably used
Meter the detergent exactly
in accordance with the man-
ufacturer's information.
Problem Possible Cause Remedy