Filter
Top Products
Operating Instructions
20
Set the delay timer / soaking duration
Delay timer
The b (DELAY TIMER) button allows the start of a washing program to
be postponed for between 1 and maximum 19 hours.
0 To do this, press the b (DELAY TIMER) button as
often as necessary until the required start delay is
shown in the multi display, for example in the
form12h for the postponement of the program
start of 12 hours.
If19h is displayed and you press again,
0h appears, followed by the run time of the set program
(display in minutes, e.g. 126). No delay timer is set in this state.
3
Once the delay timer has been set, it will only be activated after press-
ing the O/s (START/PAUSE) button.
Soaking duration
When the q (SOAKING) button is pressed, you can extend the soaking
period with the b (DELAY TIMER) button (maximum 10 hours and ap-
prox. 20 minutes).
3
Without delay timer, the soaking period is approximately 30 minutes,
plus a pre-wash time of 20 minutes.
0 To adjust, press the b (DELAY TIMER) button as often as necessary until
the required soaking period is shown in the multi display, e.g.1h
(=1 hour).
After approximately 2 seconds, the multi display
shows the run time in minutes.
This run time is made up as follows:
3
While q (SOAKING) is running, k (PRE-WASH) lights up on the
program sequence display.
Selected soaking period e.g. ih= 60 Minutes
+ Heating-up/pre-wash time e.g. Approx. 20 Minutes
+ Run time of the selected wash program e.g. Approx. 126 Minutes
= Displayed value e.g. Approx. 206 Minutes