Tripp Lite B072-016-IP4 Manual

next previous

2. Web Conﬁguration Interface

TheNetCommanderIPcanbeaccessedintwoways;locallyviathelocalconsoleOSD,orremotelyviatheWebCongurationInterface.

This section of the manual details the Web Conﬁguration Interface, which can be used to access the computer/servers and other devices

connectedtotheKVM,aswellastoconguretheKVM’ssettingsandaccounts.

2.1 Logging Into the Web Conﬁguration Interface

Note:

• Before logging on the ﬁrst time, verify that you have the latest Java installed on your computer (Java 1.6 or higher is required). If not, you

can download and install Java from http://www.java.com/en/download/index.jsp.

• Only SSL connections are allowed, so you must start the IP address with HTTPS, not HTTP.

1. Open your web browser (see the Client Computer Compatibility section of this manual for browser support) and enter in the IP address

of the KVM.

2. WhenloggingintotheKVMfromyourwebbrowser,aSecurityAlertmessageappearstoinformyouthatthedevice’scerticateisnot

trusted,andasksifyouwanttoproceed.Youhavetwooptions:

• If you are working on a computer other than your own, accept the certiﬁcate for just this session by clicking to proceed.

• If you are working at your own computer, install the certiﬁcate. Refer to the Security Certiﬁcate Installation sectionoftheOwner’s

Manual for further instructions.

3.Uponinstallingthecerticateoracceptingtheunrecognized 

 certicateforthecurrentsession,theJavaapplicationbegins

to install. Before the installation completes, a security warning

may appear stating that the connection to this website is

untrusted. This is a security issue similar to one you get from

 yourwebbrowser.Youcanchoosetocontinueanyway,or

 installthecerticateintheJavacontrolpanel.Refertothe 

Security Certiﬁcate InstallationsectionoftheOwner’sManual

for further instructions.

4. After installation has completed, the login page appears. If the

in the center of the web page to bring it up. If clicking on the Log

On button does not bring up the login page, add /targets.jnlp to

the end of your IP address.

5.Enterinyourusernameandpassword,andpressEnter.

If this is the ﬁrst time you are accessing the KVM, enter

in the default username (admin) and password (access).

The My Targets page of the Web Conﬁguration Interface

opens, showing the state of your unit, and displaying

all your available Target Servers.

13-11-081.indd 9 11/26/2013 3:31:49 PM