Tripp Lite B072-016-IP4 Manual

next previous

1. Product Overview

To set the IPv4 address via the local console OSD:

1. From the local console, press the left [Shift]keytwicetoopentheOSD.

2. Press the [F2] key to open the Settings menu.

3. In the Settings menu, press the [Tab] key until the DHCP ﬁeld is highlighted.

Press the [Spacebar] key to toggle the DHCPeldfromEnabledtoDisabled.

4. Pressing the [Tab] key to navigate to the additional ﬁelds, type in the desired IP

Address, Subnet Mask, Gateway, and DNS Server Address (Optional).

5. OncetheIPaddressissatisfactory,pressthe[Esc] key to save your changes.

ThiswillrequirearebootoftheKVMtosavethenewsettings.

To set the IPv6 address via the local console OSD:

1. From the local console, press the left [Shift]keytwicetoopentheOSD.

2. Press the [F2] key to open the Settings menu, and then press the [F2] key

again to open the IPv6 Settings menu.

3. In the IPv6 Settings menu, with the Mode ﬁeld at the top of the screen

highlighted, press the [Spacebar]keytotogglebetweenDHCP,Stateless,and

Static.DHCPisselectedbydefault,andautomaticallyassignsanIPaddress

viatheIPv6DHCPserver.Statelessisanoptionfornetworkswithacompliant

router that performs Stateless IPv6 conﬁguration. Static allows you to manually

assign an IP address.

4. Pressing the [Tab] key to navigate to the additional ﬁelds, type in the desired

IPAddress,Gateway,andDNSServerAddress(Optional).Note: DNS IP can be

set to 0.0.0.0 to indicate no DNS.

5. OncetheIPaddressissatisfactory,pressthe[Esc] key twice to exit and save

yourchanges.ThiswillrequirearebootoftheKVMtosavethenewsettings.

To set the IP address via the Web Conguration Interface:

Note:

• Before logging on the ﬁrst time, verify that you have the latest Java installed on

your computer (Java 1.6 or higher is required).

If not, you can download and install Java from

http://www.java.com/en/download/index.jsp.

• Only SSL connections are allowed, so you must start the IP address with HTTPS,

not HTTP.

1. Open your web browser (see the Client Computer Compatibility section of this

manual for browser support) and enter in the IP address of the KVM.

2. When logging into the KVM from your web browser, a Security Alert message

appearstoinformyouthatthedevice’scerticateisnottrusted,andasks

if you want to proceed.

Youhavetwooptions:

• If you are working on a computer other than your own, accept the certiﬁcate for just this session by clicking to proceed.

• If you are working at your own computer, install the certiﬁcate. Refer to the Security Certiﬁcate InstallationsectionoftheOwner’s

Manual for further instructions.

13-11-081.indd 7 11/26/2013 3:31:46 PM