Tripp Lite B064-016-04-IP Manual

next previous

4 5 6

2 3

Introduction

Browsers

Components

Supported browsers for users that remotely log into the B064-Series

KVM Switches include the following:

Browser Version

Internet Explorer 6 and higher

Firefox 1.5 and higher

Mozilla 1.7 and higher

Safari 2.0 and higher

Opera 9.0 and higher

Netscape 8.1 and higher

Front View

No. Component Description

Power LED Illuminates when the KVM switch is powered on

Port LEDs The Port LEDs will illuminate different colors depending on the status of the corresponding port:

Green – The Port LED will illuminate Green when the corresponding port is connected and powered-on

Red – The Port LED will illuminate Red when the corresponding port is selected as having the KVMs focus,

but is either not connected to a computer/server or is connected to a computer/server that is not powered-on

Orange – The Port LED will illuminate Orange when the corresponding port is connected, powered-on and

selected as having the KVMs focus

Note: The LEDs are steady under normal conditions, but will ﬂash at half second intervals when the

corresponding port is being accessed under Auto Scan Mode or Skip Mode.

LAN LEDs The Primary (Link 1) and Secondary (Link 2) LAN LEDs will illuminate different colors depending upon the

network transfer rate:

Red – The LAN LEDs will illuminate Red at speeds of 10 Mbps

Orange – The LAN LEDs will illuminate Orange at speeds of 100 Mbps

Green - The LAN LEDs will illuminate Green at speeds of 1000 Mbps

USB Ports Additional USB peripherals can be plugged into these ports (Keyboard, Mouse, etc.)

Reset Switch

Note: This switch is recessed and must be pushed with a thin object, such as the end of a paper clip or a

ballpoint pen.

•PressingandreleasingtheResetButtonwhentheKVMswitchisrunningperformsasystemreset.

•PressingandholdingtheResetButtoninformorethanthreesecondswhentheKVMswitchisrunningresets

the switch conﬁguration to the factory default settings. Note: This does not clear User Account information.

See Clear Login Information, page xx, for instructions on clearing user account information.

•PressingandholdingtheResetButtoninwhilepoweringontheswitchwillrestoretheKVMswitchtoits

original ﬁrmware in the event of a ﬁrmware upgrade failure. Note: This operation should only be performed

in the event of a ﬁrmware upgrade failure that results in the device becoming inoperable.

Port Switching Buttons •PressthePort Down button to switch from the current port to the previous port on the installation.

•PressthePort Up button to switch from the current port to the next port on the installation.

Note: The ﬁgure shows the front panel of a B064-032-04-IP. The B064-032-02-IP, B064-016-02-IP and B064-016-04-IP contain all the same

front-panel features as the B064-032-04-IP, except the B064-016-04-IP and B064-016-02-IP come with 16 ports instead of 32.