76
APPENDIX
* The first copy time and warmup time may vary depending on the power source voltage, temperature, and other environmental
conditions.
Printer Function
* The first print time and warmup time may vary depending on the power source voltage, temperature, and other environmental
conditions.
Dimensions
000" (W) x 000" (D) x 000" (H) (590 mm
(W) x 545 mm (D) x 470 mm (H)) (using
document cover and including toner
cartridge)
000" (W) x 000" (D) x 000" (H) (590 mm
(W) x 545mm (D) x 555mm(H)) (using
document cover and including toner
cartridge)
Operating conditions
Temperature: 00°F - 00°F (15°C- 30°C) Humidity: 20% - 85%
Noise level
Sound power level Lw
A
(1B=10dB)
In operation: 6.3[B]
On standby: 3.9[B]
Sound pressure level Lp
A
(bystander position)
In operation: 49[dB(A)]
On standby: 24[dB(A)]
Sound pressure level Lp
A
(operator position)
In operation: 00[dB(A)]
On standby: 00[dB(A)]
Measured according to ISO7779
Emission concentration
(measured according to
RAL-UZ62)
Ozone: 0.02 mg/m
3
or less, Particulate matter: 0.075 mg/m
3
or less
Styrene: 0.07 mg/m
3
or less
Optional equipment
Dual function board (AR-EB7)
250-sheet paper feed unit (AR-D24)
2 x 250-sheet paper feed unit (AR-D25)
Single pass feeder (AR-SP6)
Reversing single pass feeder (AR-RP6)
Print speed
16 ppm (21 ppm when ROPM enabled, Dual function board must be installed)
First print*
7.2 sec.
Resolution
600 dpi
IMC memory
16 MB
Two-sided printing
function
Yes (AR-M205)
Paper feed method
Same as for copying
Offset function
Offsets each print job
Supported operating
systems
Windows 95/98/Me, Windows NT 4.0 Workstation, Windows 2000 Professional
Windows XP Home Edition/Professional
(Detailed information can be found in the SOFTWARE SETUP GUIDE)
Emulation
SHARP GDI
Expansion memory
Up to 256 MB can be added by installing a 32 MB, 64 MB, 128 MB or 256 MB
expansion memory module (168-pin SDRAM DIMM) in one DIMM expansion slot
(Dual function board must be installed)
Maximum of 272 MB including IMC memory.
Port
IEEE1284 parallel port/
USB port (USB1.1), USB port (USB2.0, Dual function board must be installed)
Interface cables
[Parallel cable]
Shielded bi-directional (IEEE1284) cable (max. length 3 m)
Please purchase a commercially available parallel cable.
[USB cable (only for connection to USB 1.1 port)]
Shielded twisted pair cable (max. length 3 m)
[USB cable (only for connection to USB 2.0 port)]
Shielded twisted pair cable (max. length 3 m, must support USB 2.0)
Please purchase a commercially available USB cable.
