54
TROUBLESHOOTING
Paper size for a paper tray cannot
be set.
Is copying, or printing being performed?
→ Set the paper size after copying or printing is complete.
00
Has the machine stopped temporarily due to running out
of paper or a misfeed?
→ Load paper or remove the misfeed, and then set the paper size.
00
Is an interrupt copy job in progress?
→ Set the paper size after the interrupt copy job is finished.
00
Is data being held in memory?
→ The original data indicator and the display will blink when data is
held in memory because a copy job that uses automatic
two-sided copying, dual page copy, 2 IN 1 / 4 IN 1 copy, or
sort/group copy has stopped before it is finished (when the Dual
function board is installed).
→ When the Dual function board is not installed, the display will
blink when data is held in memory because a copy job has
stopped before it is finished. Finish the interrupted copy job or
clear the data from memory.
00
A copy job stops before it is
finished.
Is the output tray full?
→ Long copy runs are automatically paused every 250 copies.
Remove the copies in the output tray and press the [START] key
( ) to resume copying.
00
Does "FUL" appear in the display?
→ The memory became full during sort/group copy or 2 IN 1 / 4 IN 1
copy. Copy only the originals that have been scanned to that
point, or cancel the job and clear the data from memory.
00
Is the tray out of paper?
→ Load paper.
00
Is the POWER SAVE indicator lit?
Are any other indicators lit?
→ If other indicators are lit, the machine is in preheat mode. Press
any key on the operation panel to resume normal operation.
00
Is only the POWER SAVE indicator lit?
→ If only the POWER SAVE indicator is lit, the machine is in auto
power shut-off mode. Press the [START] key ( ) to resume
normal operation.
00
Alarm indicators
( , , , , ) are lit or
blinking.
See "INDICATORS AND DISPLAY MESSAGES" to check
the meaning of the alarm indicators and error messages
in the display, and take appropriate action.
00
Lighting fixture flickers.
Is the same power outlet used for the lighting fixture and
the machine?
→ Connect the machine to a power outlet which is not used for other
electric appliances.
00
Problem Cause and solution Page
