45
USER SETTINGS
5
*
1
On models with a SPF/RSPF.
*
2
On models with a dual function board.
*
3
On models with automatic two-sided copying.
23
Resolution in Auto/
Text mode
1: 300dpi
2: 600dpi
• The copy resolution in auto and text mode is
normally 300 dpi. If high-quality copies are
preferred, use this setting to change the
resolution to 600 dpi.
24
Memory allocated to
printer mode
1: 30%
2: 40%
3: 50%
4: 60%
5: 70%
• Use this to change the proportion of machine
memory used for printer mode.
25
Key auto repeat
0: OFF
1: ON
• Use this setting to select whether or not
holding down a key causes repeated input of
the key. For keys that normally cause a set
value to increase when held down (for
example, holding down the [ZOOM] key (
,
)), this program can be used to have the set
value not change when the key is held down.
26
Key press time
1: Minimum
(current
response speed)
2: 0.5 sec.
3: 1.0 sec.
4: 1.5 sec.
5: 2.0 sec.
• Use this setting to select how long a key must
be pressed for the input to be accepted. By
selecting a longer time, you can prevent
settings from being changed by the accidental
pressing of a key.
27
Audible signals volume
1: Low
(current
volume)
2: High
3: OFF
• This sets the volume of beep signals. (p.00)
28
Base setting beep
signal
0: OFF
1: ON
• Use this to sound a beep when a base setting
is selected.
29
Number of copies limit
1: 99 copies
2: 999 copies
• Use this setting to change the maximum
number of copies that can be selected from 99
to 999.
30
Use close paper size
0: OFF
1: ON
• When this function is enabled, printing in
printer mode will automatically continue using
a different size of paper if the specified size of
paper runs out in all trays. This feature does
not function in copy mode.
31
Default tray setting
1: Tray 1
2: Tray 2
3: Tray 3
4: Tray 4
5: Bypass tray
• Use this program to select a default tray. This
tray is automatically selected each time the
power is turned on or each time the machine
reverts to the initial settings.
32
Default exposure
mode
1: AUTO
2: TEXT
3: PHOTO
• Use this program to set "AUTO", "TEXT", or
"PHOTO" as the default exposure mode.
Program
number
Program name
Setting codes/
factory default
setting
(factory default setting
appears in bold)
Explanation
