Message Cause Solution
"Data storage error." You tried to print a Sample Print,
Locked Print, Hold Print, or
Stored Print file while the hard
disk was not installed.
The hard disk is required when
printing a Sample Print, Locked
Print, Hold Print, or Stored Print.
If the message appear after
installing the hard disk, contact
your service representative.
"Duplex has been cancelled." Duplex printing was canceled. • Select the proper paper
size for the duplex
function. For details about
paper size, see page 38
"Paper Size
Specifications".
• Change the setting for
"Apply 2 sided" in [System
Settings] to enable duplex
printing for the paper tray.
For details about setting
"Apply 2 sided", see "Tray
Paper Settings", Operating
Instructions.
"Error has occurred." A syntax error, etc., occurred. Check that the PDF file is valid.
"Error occurred. Either job was
printed with settings changed or
it was cancelled."
An error occurred during
printing, but it was skipped.
Check that the data is valid.
"Excdd max. No. of files to print
for temp./stored jobs."
While printing a Sample Print,
Locked Print, Hold Print, or
Stored Print file, the maximum
file capacity was exceeded.
Delete unneeded files stored in
the printer.
"Excdd max. No. of files.(AT)" While using the error job store
function to store Normal Print
jobs as Hold Print files, the
maximum file capacity for file
storage or Hold Print file
management (automatic) was
exceeded.
Delete Hold Print files
(automatic) or unneeded files
stored in the printer.
When Messages Are Displayed
91
