4 - 5
No. 99MBC032A
4. SETTING UP THE MEASURING CONDITIONS
c. Putting a comma after the thousandths digit (Guidance: )
Set whether a comma ( ,) is inserted after the thousandths digit.
: Not displayed →
: Displayed →
(Default setting is .)
PROG
Step 1: Each time the key is pressed the displayed
string toggles between
and .
Select the setting and press the
ENT
key.
After accepting the specified digit position, the
display proceeds to the setting the buzzer function.
d. Setting the buzzer function (Guidance: )
Set whether or not to enable (key input sensing sound and key entry error sound) and
(±NG judgment sound). Note that the system error sounds (indicating that the printer or
Digimatic Output Unit is not connected, or other system failures) are not disabled with this
setting.
The types of buzzer sound are as follows:
1. Key input sensing sound: very short beep (0.05 sec)
2. Key entry error sound: short beep (0.2 sec)
3. ±NG judgment sound: long beep (1 sec)
4. System error sound: repeated short beeps at intervals of 0.2 seconds
: Sounds a buzzer in all cases.
: Enables the key input sensing sound + key entry error sound
: Sounds a buzzer when the judgment result is ±NG
: Sounds a buzzer only if a system error occurs
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option changes in the following order:
→ → → . If the
desired option is flashing, press the
ENT
key.
When the setup for the buzzer function is com-
pleted, operation automatically proceeds to the
setting of the display latch timer.
