A SERVICE OF

logo

Open as PDF
next previous
6 - 20
No. 99MBC032A
(24) AUT, S
(a) Format: AUT, S
(b) Description: Where “Performing the automatic workpiece detection” is specified in the basic
setup, and if this command is received, “S” will be responded each time a
workpiece is detected.
If this setup is not made in the basic setup, designating this command results
in ER6.
(c) Example: Reception command AUT, S
Response command OK
(25) RA
(a) Format: RA
(b) Description: Transmits as the response the conditions of the automatic workpiece detection
using RA FORMAT.
(c) Example: Reception command RA
Response command AUT, N50, D15, L9.5, H12.3
(26) Timing signal
If the measuring operation is interrupted by a command from the key operation, an ER7 will be
responded to the RS-232C interface.