Appendix B: Migration CLI
The Migration CLI is a tool that allows you to configure an ACS 6000 console server that is
running scripts based in the ACS advanced console server. For full configuration and
management commands, it is recommended you use the ACS 6000 console server’s CLI.
NOTE: Referencesto an ACS advanced console server in thissection refer to anyadvancedconsole server other
than the ACS 6000 console server.
In the ACS 6000 console server, the login profile for the user “root” goes directly to the shell
prompt. This will allow the root user to run Migration CLI commands out of the ACS 6000
console server. A new group, “login-profile-shell,” is created with only root as a member. To
run commands based from an ACS advanced console server, a root user should type CLI before
the command.
Access rights
The access rights on the ACS 6000 console server are based on authorization groups. The
administrator configures the serial ports the group can access. To allow you to configure access
rights, the following table displays authorization groups that will be created on the ACS 6000
console server when using the Migration CLI.
Group Members Permissions
cli_mus_ttySxx
Userswho can open a second
session to aserialport.
Accessto aserialport in amuli-
session (read/write or read only)
cli_power_ttySxx
Userswho have power controlin a
serialport.
Power control(on/off/cycle) of
outletsmerged to aserialport.
cli_access_ttySxx
Userswho can accessa serialport in
a single session.
Accessto aserialport in asingle
read/write session.
cli_pmd_
<username>
<username> Power controlof the outlet.
Table B.1: Access Rights Groups
Exceptions
This section will list all ACS advanced console server CLI commands not available in the
Migration CLI for the ACS 6000 console server. For a list of available commands, see the
Cyclades ACS Installation/Administration/User Guide.
The following commands or values are not supported by the Migration CLI:
Appendices 53
