Filter
Top Products
19
After this procedure, it will be necessary to set
the programme and the options again and then
to depress button 8.
At the end of the programme
The machine stops automatically. Some
acustic signals sound and on the display will
appear a flashing «
0 ». The light of button 8
and the light 9 go off. The door can be
opened.
If at the end of a programme there is water in
the tub, the light
9 remains on and the door is
locked to indicate taht the door must be empty
out.
To empty out the water follow the following
instructions:
1. turn the programme selector dial to «O»
2. select the DRAIN or SPIN programme
3. reduce the spin speed, if needed, by
pressing the button
2
4. depress button 8
5. at the end of programme, the display shows
a flashing zero «0», the light 9 goes off and
it will be possible to open the door.
At the end of the cycle, turn the programme
selector dial to «O» to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash,
close the water tap.
Leave the door open to prevent the formation
of mildew and unpleasant smells.
132964330.qxd 19/06/2008 14.41 Pagina 19