Filter
Top Products
Using your mobile phone _45
03 USING YOUR MOBILE PHONE
Using your mobile phone
You can receive notifi cations and control your washer on your mobile phone.
To do this, you need to do the following.
1. Confi gure the Wi-Fi settings of your washer and connect the washer to your network.
2. Turn on the Wi-Fi networking function of your washer.
3. Download, install, and then run the mobile app, Samsung Smart Washer/Dryer App
4. Use the mobile app, Samsung Smart Washer/Dryer App.
No wired or wireless router (AP) is provided when you purchase your washer. The washer supports
the Wi-Fi encryption protocols, WEP, TKIP and TKIP AES. It does not support connecting to a wired or
wireless router (AP) that uses a Wi-Fi encryption protocol other than these.
• If a wireless router (or Access Point) is not WPS authenticated, a connection failure may occur.
• If a wireless router that is not WPS authenticated is connected wirelessly to an air conditioner, the
Wi-Fi connections of other previously connected units might be disconnected.
• If this appliance is installed in a building where no wireless router (AP) is installed for that fl oor, the
network connectivity may be degraded.
• If this appliance is installed in a location such as inside a utility closet made from metal or reinforced
concrete, the network connectivity may be degraded.
• If this appliance or the wireless router (AP) is installed near a microwave or drier, the network
connectivity may be degraded due to interference.
• If the wireless router (AP) is a non-certifi ed product, this appliance may not connect to the network.
• This appliance does not support the wireless networking protocols 802.11n and 802.11a.
This product does not contain a wireless router.
CONFIGURING YOUR WASHER’S NETWORK SETTINGS AND
CONNECTING TO YOUR NETWORK
To confi gure your washer’s Wi-Fi settings and connect your washer to your network, follow the procedures
below.
Confi guring the IP address settings
Follow the procedure below to confi gure the IP address settings of your washer for a Wi-Fi
network.
1. Tap the Settings button in the Cycle
Selection screen.
2. Tap the Network menu in the Settings screen.
3. Tap the Wi-Fi network section.
4. Tap the Confi gure button.
5. Tap the IP Address button next to the network
you want to confi gure.
6. Tap the Automatic button to have your washer
confi gure the IP address settings automatically.
Then proceed to step 11.
7. To confi gure the IP address settings manually, tap the User Confi g button.
8. Tap the IP address fi eld.
9. Enter an IP address and then tap the OK button.
10. Repeat steps 8 and 9 for the Subnet mask, Gateway, and DNS fi elds.
11. Tap the OK button in the Settings screen.
CAUTION
WF457ARG-03153A-04_EN.indd 45WF457ARG-03153A-04_EN.indd 45 2012-08-31 12:30:302012-08-31 12:30:30