Samsung WF457ARGSWR Washer User Manual


 
20_ Installing your washer
Installing your washer
INSTALLING YOUR WASHER
Before STEP 5 is complete, do not plug the power cord into a wall socket.
Packaging materials can be dangerous to children; keep all packaging material (plastic bags,
polystyrene, etc.) well out of the reach of children.
Installation fl ow chart
Selecting a
location
Running a Calibration mode
(Refer to the following
description)
Finish the
installation
Removing the shipping
bolts (*Drum only)
Connecting the water
and the drain
Adjusting the
levelling feet
Powering your washing
machine
[Running a test cycle]
Run a test cycle (Rinse+Spin) with
small amount of laundary
(about 4~5 Towels)
Yes
Please
check again
before
steps.
No
Does
your washer
have excess vibration
or noise?
STEP 1
Selecting a location
Before you install the washer, make sure the location:
Has a hard, level surface without carpeting or fl ooring that may obstruct ventilation Is
away from direct sunlight
Has adequate ventilation
Is not exposed to freezing temperatures (temperatures are never below 32 °F or 0 °C)
Is away from heat sources such as oil or gas
Has enough space so that the washer doesn’t stand on its power cord
STEP 2
Removing the shipping bolts
Before installing the washing machine, you must remove all
shipping bolts from the back of the unit.
1. Hold the shipping bolt with your hand and pull it through
the wide section of the hole. Repeat for each shipping bolt.
2. Fill the holes with the supplied bolt hole covers.
3. Store the shipping bolts in a safe location where they can
be easily retrieved in the event that you have to move the
washing machine in the future.
CAUTION
WARNING
WF457ARG-03153A-04_EN.indd 20WF457ARG-03153A-04_EN.indd 20 2012-08-31  12:30:212012-08-31  12:30:21