Russell Hobbs RHWM61200B Washer User Manual


 
Installation
7
4. Adjust the level of washing machine by the adjustable feet. Please check if there is a gap
between the four adjustable feet and the floor. If there is then adjust the level of the
washing machine by turning the adjustable feet. Make sure that the machine does not
sway and that it is completely level. After the adjustment is finished, turn the fixing nuts
up tightly, so that the adjustment that has been made is fixed.
NOTE
The machine should not sway and all the adjustable feet should sit/touch the floor.
Location of the Washing Machine
• Check location where the washer will be installed. Make sure you have everything
necessary for correct installation.
Do not place or store your washer below 0°C (32°F) to avoid any damage from freezing.
• Do not place or store laundry products on top of washer at any times.
• Install the washer on the horizontal solid floor, flat, non-slippery and tough floor. Do not
install onto a carpet.
If the washer is installed on an unsuitable floor, it could make considerable noise, vibrate
severely and cause a malfunction. If the washer is not level, adjust the leg up or down for
horizontal installation.
Never put cardboard, wood or other materials under your machine to try and stabilise
the unit
Ventilation openings must not be obstructed.
Leave some space (right & left : 2cm, rear : 10cm).
In case of built-in installation, the distance between top of the washer and bottom of
upper plate should be at least 3mm.