Filter
Top Products
How to use
16
• The Easy iron and Rinse hold functions cannot be used in conjunction
Function indicator lights
• When the Start/pause button or any function button is pressed, the corresponding light
turns on.
• The light turns off when the function button or start/pause button is re-pressed, or
when the process that has been selected is complete.
Important note
The function indicator lights are also used in failure detection system mentioned in
section 9.
To cancel/reset a programme
• If you want to cancel/reset a programme after it has started, press the Start/pause
button, turn the programme dial to the stop.
• Wait while the Ready light goes out, turn the dial to the required new programmed, wait
again while the Red light comes on and the press the Start/pause button.
• Once a new programme is selected the product will discharge the water from the old
programme.
To end a running programme
• If you want to end a running program early, press the Start/pause button and turn the
program dial to the Stop position.
• Turn the program dial to “Drain” or “Spin” programmes.
• The program ready light will come on and press the Start/pause button.
Programme ending
• Your machine will automatically stop when the programme you have selected ends and
the End light will come on.
• Turn the program dial to Stop position and wait for approximately 2 minutes until the
door is unlocked and it can be opened.
• You can open the door by pulling the handle of the door towards yourself and you are
now able to take out your laundry from the machine.
• After you have unloaded your laundry from the machine leave the door open so the
interior of your machine can dry.
• Turn of the power at the plug socket and unplug your machine.