Filter
Top Products
—
4
—
1. Features
1 Speed drying
Equipped with a turbo fan, the hand dryer blows away drops of water on the hands with a high-speed jet air
from a large air volume, high-speed rotary DC brush-less blower, thus quickly draying the hands.
2 Easy to use
The rubbing of the hands is no longer necessary. With the hand dryer, you can dry both hands by just insert-
ing and then removing them slowly.
3 Hygienic
• The hand dryer is automatically started by a sensor. Thus, there is no need to touch the hand dryer with
your wet hands. It is very hygienic.
4 Antibacterial
• The hand dryer uses a silver inorganic substance; thus, maintaining an antibacterial effect for an extended
period of time.
• The hand dryer meets the antibacterial effect standard defined by the Society of Industrial Technology for
Antimicrobial Articles (SIAA).
5 Easy maintenance
The hand dryer does not require a paper or cloth towel, thus eliminating the dumping of paper waste and the
exchanging of towels. Also, the hand dryer is easy to clean.
6 Highly safe with mischievous use prevention timer
To prevent continuous operations of the hand dryer by mischievous use or malfunction, it has a built-in timer
that automatically stops drying upon reaching a specific period of time.
7 Economical
The monthly electricity expense is the only expense the hand dryer requires. Thus, it is extremely economi-
cal for use over an extended period of time.
• Inspect the condition of the earth. Correct it if improperly grounded. Also, check to see if a ground fault circuit
interrupter is being installed. If not, install one.
• Check to see whether or not the air filter and the drain tank are installed securely in place.
• Do not leave a towel or other object in the hand-drying area.
• Never place any object on the main body nor cover it.
• Make sure that the product is not being used in any of the following locations:
Locations where the temperature can exceed 0°C to 40°C.
Locations where the humidity can exceed 5%RH to 95%RH.
Locations where the unit may come into direct contact with water.
Locations where the unit is under direct or strong sunlight. (May cause sensor to malfunction.)
Locations where there is a lot of condensation.
Do not use with chemicals (detergents, etc.) on your hands. (This may reduce the productive life of the unit.)
Do not use in locations where corrosive, neutral, or reductive gases are present.
(This may reduce the productive life of the unit and/or cause malfunctions.)
Locations where solt damage may occur.
Places lower than -20m or higher than 2000m above sea level.
Items to check during repair work
●Upon completing repair work, verify that the product operates normally. Clean the product's main body and sur-
rounding area, and notify the customer of the completion of the repair work.