Filter
Top Products
Plumbing
Connect the water supply hose (the
hose marked blue) to the cold water
valve.
Turn on the valve and check for leaks.
The water pressure must be within
15-145 psi (1-10 bar). If the water pres
-
sure is greater than 145 psi
(10 bar), a pressure reducer must be
installed. If the water pressure is below
15 psi (1 bar), insufficient water may be
available for a complete fill.
The water supply hose is equipped with
a filter; please do not remove this filter.
Connection to the drain sys
-
tem.
The 5 ft. (1.5m) drain hose may be con
-
nected as follows:
1. Directly into a sink: hook the hose
over the edge of the sink and secure
it firmly (e.g. by tying the hose to the
water faucet).
2. To a stand pipe: place the drain
hose
into a 1
1
/
2
“ (38 mm) stand pipe and
firmly secure it.
3. To a floor drain: The machine is
equipped with an airgap/anti-siphon-
ing system so that no minimum drain
height is required.
– The machine drains using a pump
with a maximum delivery height of 4
ft. (1.2 m).
– Make sure there are no kinks in the
drain hose.
– If desired, the drain hose may be ex-
tended to 15 ft. (4.5 m) maximum.
Plumbing
33