Filter
Top Products
Fault messages in the display
Problem Possible cause RemedyA
The display lights up
;
and
Drain fault
flashes.
–
The water outlet is
restricted or
blocked.
–
The drain hose is
sitting too high.
–
Clean the drain filter and
pump.
–
The max. drain pump
height (delivery head) is
1m.
The display lights up
;
and
Water inlet fault
flashes.
The water inlet is
blocked or restricted.
Check whether:
–
the stopcock is open
enough.
–
the inlet hose is pinched or
bent.
– the water pressure is too
low.
The display lights up
;
and
Waterproof fault
flashes.
The water protection
system was triggered.
Call the service department.
The display lights up
;
and
Technical fault
flashes.
There is a fault. Re-start the program.
If the fault message appears
again, call Customer Service.
The display flashes
Anti-crease
Chk detergent
Excessive foam has
built up during
washing.
Use less detergent next time,
and check the recommended
doses on the package.
A To switch off the fault message: Use the I-On/0-Off button to switch the washer
off.
Troubleshooting
35