Filter
Top Products
Fault messages in the display
Problem Possible cause Remedy A
q
Fault
Check drainage
system
–
The water outlet is
blocked or
restricted.
–
The drain hose has
been fixed too high.
–
Clean the drain filter and
the drain pump.
–
The maximum drain
height is 1 m.
p
Fault
Water intake
Open stopcock
–
The water inlet is
blocked or
restricted.
Check whether
–
the stopcock is opened
wide enough.
– the inlet hose is kinked.
o
Waterproof
activated
Close stopcock
The water protection
system has reacted.
Call the Service
Department.
ä
Fault
Drum lighting
The drum lighting is
not locked in position.
Check that the drum
lighting is sitting correctly.
,
Technical fault
Call the Service
Department
There is a fault. Start the programme again.
If the fault message
appears again, contact the
Service Department.
The following will flash in
the display:
Anti-crease
alternately with
Check detergent
Excessive foam has
built up during
washing.
Use less detergent next
time and follow the
manufacturer's instructions
on dosage given on the
packaging.
A To switch off the fault message: Switch the washing machine off with
I-On/0-Off
button.
Problem solving guide
37