Filter
Top Products
This machine has fully electronic
controls with automatic load
recognition. It takes in the right amount
of water required for the programme
depending on the amount of laundry
and its absorbency rate. This means
that programme cycles and durations
can vary.
The programme sequences outlined in
the chart are based on the basic
programme with a full load. Extra
options which can be selected have not
been taken into account.
The programme sequence display
shows the stage the programme has
reached.
Special features in the programme
sequences:
Anti-crease:
At the end of every programme, with
the exception of the
Woollens
programme, the drum continues to turn
at intervals for up to 30 minutes to help
prevent creasing. The door can be
opened and laundry removed at any
time during the anti-crease phase.
1)
Pre-rinse: A pre-rinse without
detergent is carried out automatically
to remove dust.
2)
Run-up to spin: A run-up to spin is
carried out before the wash process
begins to deflate the pillows.
Subsequent water intake for the main
wash is through compartment j.
3)
A second rinse is carried out when
when a temperature of 60°C to 95°C
has been selected. A third rinse is
carried out when a temperature
below 60°C is selected.
A third/fourth rinse is carried out if:
–
there is too much foam in the drum
–
a spin speed lower than 700 rpm has
been selected
–
Without spin
has been selected
4)
A third rinse is carried out if:
Without spin
has been selected
5)
In the
Outerwear
programme,
laundry is only spun after the main
wash.
Programme sequence
26