IAdding detergent
It is important to dispense the correct
amount, because. . .
. . . too little detergent results in:
–
Laundry not getting properly clean
and with time it may become grey
and hard to the touch.
–
Greasy particles cling to the laundry.
–
Limescale deposits on the heater
elements.
. . . too much detergent results in:
– Excessive foam, which causes a low
level of agitation and poor wash,
rinse and spin results.
– higher water consumption because
an extra rinse is automatically
activated
– A burden to the environment.
^
Pull out the detergent drawer and
place detergent in the compartments
as follows:
i = Pre-wash
(if selected, add
1
/
4
of the
total amount recommended for
the programme). This compart-
ment is also used for starch
formulations when starching
separately.
j = Main wash
including the Soak period if
selected
§ = Fabric conditioner or
liquid starch.
^
Close the detergent drawer.
See section on "Detergent" for further
information on detergent and the
amount to dispense.
JPress the Start button
This starts the programme. The
maximum programme duration will then
show in the display.
Garment care label symbols
24