Filter
Top Products
Installation site
,
Make sure the dryer door can be
opened without hindrance after
installation.
Transporting the machine to its
installation site
When moving the machine you can
hold it by the lid where it protrudes to
the rear of the dryer. To manoeuvre the
dryer out of its packing case to its
installation site you will also need to
hold it by the front feet.
Building under a continuous worktop /
in a row of kitchen units
,
It is very important to avoid a
build up of heat.
The warm air which is expelled from
the rear of the dryer must be able to
dissipate. Otherwise drying times
will be increased unnecessarily.
You can ensure that the warm air can
dissipate by:
–
Adjusting the screw feet so that there
is a gap of at least 20 mm between
the floor and the bottom of the dryer.
–
Creating a gap for the dryer in the
kitchen furniture plinth facing.
–
Creating ventilation gaps in the
kitchen unit.
,
The dryer should not be installed
next to a refrigerator or freezer. The
warm air expelled from the rear of the
dryer would increase the temperature
around the refrigerator's/freezer's heat
exchanger causing the compressor to
run continuously.
If it is not possible to install the dryer
anywhere else, then the
refrigerator/freezer must be sealed off
from the dryer.
If you wish to push your machine under
a worktop and there is space to do this
without removing the lid, a building
under kit* is not necessary. Otherwise
the building under kit is essential.
,
The building under kit* must be
fitted by a suitably qualified person.
The machine lid is replaced by a
coverplate.
It is essential that the cover plate is
fitted to ensure electrical safety.
The building-under kit is supplied with
its own installation instructions.
–
The electrical socket must be
located in an accessible position
near the machine.
With niche heights of:
–
840 mm, longer screw feet* are
required.
–
870/885 - 915/930 mm, one or two
height adjustment frames* are
required.
* Available as an optional accessory
from your Miele dealer or the Miele
Spare Parts Department.
Installation and connection
39