Filter
Top Products
Problem Possible cause Remedy
The drying
process goes
on too long or
even
switches off.
Important: Before attempting to remedy one of the following
causes, switch the dryer off and switch on again to start the
programme again.
Ventilation to and from the
dryer may be insufficient (e.g.
because it is installed in a
small room). This has caused
the temperature in the room to
rise sharply.
Open a door or window while
the machine is in operation for
increased air flow.
The opening in the hygiene
filter panel is blocked.
–
Remove any objects that are
blocking the opening.
It is possible that the hygiene
filter is very dirty even though
the
Change filter
indicator light
has not come on.
–
Replace the hygiene filter
(see "Cleaning and care -
Replacing the hygiene filter").
– Always keep the area around
the machine free of dust and
fluff.
The fluff filters are clogged up
with fluff or were still wet when
they were replaced.
– Remove any fluff.
– The fluff filters must be
completely dry.
Detergent residues, hair and
fine fibres can block up the
condenser unit.
Check the condenser unit from
time to time and clean it if
necessary (see "Cleaning and
Care").
The laundry has not been
spun sufficiently.
Make sure that your laundry is
thoroughly spun at the
appropriate spin speed.
The tumble dryer has been
overloaded.
Do not exceed the maximum
load for the programme
selected.
Metallic components, e.g. zips
have prevented the dryer from
registering the correct
moisture level in the laundry.
–
Open zips next time.
If the problem occurs again, dry
garments with long zips using
"Timed drying - Warm air".
Problem solving guide
32